For Amateur, DIY and Professional, Trade use.

Surface Cleaner is a wash treatment that kills and prevents mould and stains in wood, hardwood, paviers, slabs, tiles, concrete and masonry - clear, odourless and low toxicity. Always use the cleaner to kill the Mold first before painting, staining or oiling, otherwise the mold spores can grow through even the best anti-mold finishes.

Mix the Mold Cleaner Concentrate with water to make 5 litres of solution and wash down all affected surfaces with a sponge. Allow to dry. Add one paint treatment concentrate to each 2.5 litres of paint (any paint type) and mix thoroughly.

Usage rate - covers approximately 6 square metres per litre = 30 square metres per 500cc concentrate. Or, use the pre-diluted Cleaner in the Spray Bottle or Scrub Out Bottle and replenish from the mixed concentrate.

Mold Cleaner Refill - concentrate - makes 5 litres -

Mold Cleaner Spray -

Mold Scrub Out -

Ultra Mold Cleaner Home Pack - Kit No. 5 -

(includes Spray, Scrub Out and a Mold Cleaner Concentrate)

Boracol 10RH - For Professional, Trade use.

Boracol 5RH - For Amateur, DIY use.

Use Boracol 10RH or 5RH - where a combined Fungicide and Mouldicide is required and water is acceptable as a carrier. Examples - yacht teak decks, yacht ropes, patio and deck timbers, roof timbers with mould and insect attack, mould affected sub-sites after flooding. Boracol 10RH and 5RH contain Borate, Mouldicide, Water and Glycol. Apply by brush or sprayer. Non-staining and only 1 hour re-entry. They have no smell and no vapour.

Usage rate - for treatment of decks, patios, balconies. Apply at an average rate of 4 square metres per litre, until wet, but not dripping. Apply two coats (10RH) or four coats (5RH) allowing to dry in between.

Frequently purchased with this product - Mask (for Spraying), Sprayers, Boron Ultra Gel (for areas of heavy infestation, or dampness), Box of Vinyl Gloves (100, uni-handed).

£72.00 for Boracol 10RH 5 litres, £58.85 for Boracol 5RH 5 litres.

£298.00 for Boracol 10RH 25 litres, £8.78 for a Mask, £10.97 for a box of gloves, all plus VAT.

Boracol 10RH, 5 litres - - Boracol 10RH, 25 litres -

Boracol 5RH, 5 litres - Boracol 5RH, 25 litres -

Mask - Gloves -

Buy 5 litre Sprayer -

Buy 12 litre Knapsack Sprayer -

Boron - For Amateur, DIY use and for Professional, Trade use.

Apply to all vulnerable timbers - for example: end grain, notches, joints, plated, screwed and nailed areas - anywhere where water can settle and penetrate.

Boron Ultra Gel is a honey-like liquid. It is a higher concentration surface treatment for woodworm, Death Watch Beetle and rots. Also for protection where the timber has become wet and is vulnerable to attack by insects and rots, or for new timbers being installed in a damp area. Apply by brush. It can stain if too much is left on the surface after absorption has completed, so always remove excess with a damp cloth. It has no smell and no vapour.

Usage rate - allow about 4 square metres per litre on smooth timber, more if the surfaces are rough.

Frequently purchased with this product - Boron Ultra Paste, (for injecting into thick timbers and damp areas, like the bearings ends of joists in walls), Box of Vinyl Gloves (100, uni-handed).

£21.00 for 500cc, £32,90 for 1 litre, £61.20 for 2 litres, £10.97 for a box of 100 gloves, all plus VAT.

Buy 500cc Boron Gel -

Buy 1 litre Boron Gel -

Buy 2 litres Boron Gel -

Buy Box of 100 Gloves -

Brushing Gel onto wood

Ultra Proof - 5 and 25 litres - breathing water repellent

Can be used on wood, hardwood, paviers, slabs, tiles, concrete and masonry .

Water based, acrylic layer forming water repellent for wall and floor treatment. Repels water on outside walls, prevents dusting on concrete floors, primes and seals all types of plaster, render, brickwork and stonework. Can be over-painted or applied over paints, to lengthen life and reduce dirt build up. No solvents, no smell. Can be applied to a damp wall. Usage rate - allow up to 4 square metres per litre, by brush or low pressure, coarse spray.

Frequently purchased with this product - 12 litre Knapsack Sprayer with spray lance, suitable for sprayer all water based fluid products, as well as your garden

£49.50 - 5 litre £181.50 - 25 litre plus VAT

.Buy Ultra Proof Repellent 5 litre

Buy Ultra Proof Repellent 25 litre

Buy Knapsack Sprayer 12 litre

Combine Boron Rods and Boron Paste - drill a 10mm hole, drop in a Boron Rod, inject Boron Paste.

Boron Ultra Paste is a smooth white paste for use inside timber. Apply by injection, using the extensive tube provided. It has no smell, but can stain if any is left on the surface - wipe off excess with a damp cloth. It has no smell and no vapour. For woodworm treatments, including part of a Death Watch Beetle treatment. For woodworm and rot treatments where timbers are damp and are likely to remain damp, or become seasonally damp - e.g. window frames, joist ends, beam ends, wall plates, door posts, garden posts.

Usage rate - use our chart of hole spacings for various timber sizes as a guide, or call us on 01626 331351 and we'll calculate your exact requirements. (Hole Spacing Guide - click here to download)

£29.10 for 400cc cartridge, £10.97 for a box of 100 gloves, all plus VAT.

Boron Rods are made of high concentration fused Borate, for use inside timber. They are designed to slowly dissolve inside the wood, spreading a zone of treatment around each hole. They have no smell and no vapour. For woodworm and rot treatments where timbers are damp and are likely to remain damp, or become seasonally damp - e.g. window frames, joist ends, beam ends, wall plates, door posts, garden posts. Provides a long term reservoir of Boron protection - e.g. sheds, fence posts, window frames, timber framed buildings.

Usage rate - use our chart of hole spacings for various timber sizes as a guide, or call us on 01626 331351 and we'll calculate your exact requirements. (Hole Spacing Guide - click here to download)

Frequently purchased with this product - Boron Ultra Gel, (for brushing onto thick timbers and damp areas, like the bearings ends of joists in walls), Box of Vinyl Gloves (100, uni-handed), Plastic Plugs (colour choice - red brick, dark brown, cream limestone, 10mm diameter, tapered)

£14.92 - 8mm x 24mm packet of 10, £22.90 - 8mm x 65mm packet of 10, all plus VAT

Buy Boron Paste, 400cc cartridge with extension

Gloves 10mm plastic plugs

Buy Boron rods, 8mm x 24mm pack of 10 8mm x 65mm pack of 10

10mm plastic plugs pack of 25 Gloves

Post Repair Putty - repair the bases of posts where they rot - Mouldable Epoxy Putty forms a new damp proof foot

Joist and Post End Repair Plates are supplied as pairs of galvanised steel plates, pre-drilled, to be fixed with Coach Screws (included). The plates rest in or on the wall and allow for the rotted end to be cut off.

BM6 Plates - allow for up to 6 inches, 150mm, to be cut off - joist or post size 4 inches, 100mm deep, or more

BM9 Plates - allow for up to 9 inches, 225mm, to be cut off - joist or post size 4 inches, 100mm deep, or more

Only for joists or posts 6 inches, 150mm, deep (joists) or 150mm x 50mm (posts) or larger,

BM17 Plates - allow for up to 17 inches, 432mm, to be cut off

BM6 Kit - - £19.56 plus VAT

BM9 Kit - - £24.51 plus VAT

BM17 Kit - - £35.97 plus VAT

Joist Splice Plate Kits are supplied as pairs of plates made from anodised aluminium treadplate, un-drilled, to be fixed with self drilling and tapping screws (included). The plates allow you to joint domestic joists and posts at any point along their length.

JSP Small Kit - for joists from 4 inches up to 6 inches, 100mm - 150mm, in depth

JSP Medium Kit - for joists from 6 inches to 8 inches, 150mm - 200mm, in depth

JSP Large Kit - for joists from 8 inches up to 10 inches, 200mm to 250mm, in depth

JSP Special Medium Kit - for joists from 6 inches to 8 inches, 150mm - 200mm, in depth, but with extra long plates, for sequential repairs requiring higher strength.

JSP Small Kit - - £19.48 plus VAT

JSP Medium Kit - - £23.80 plus VAT

JSP Large Kit - - £32.68 plus VAT

JSP Special Kit - - £32.68 plus VAT

Simply take equal portions in gloved hands and mix together, like window putty or bread dough, until a perfectly even colour. Apply with a pallet knife or by hand placing. Can be sanded and painted, or left a natural buff colour. Can also be coloured with Mortar Powder or you can add you own stone dust to the finished surface whilst uncured.

Usage rate - 1 litre of putty will fill a hole 4 inches x 4 inches x 4 inches (100mm x 100mm x 100mm).

Frequently purchased with this product - Vinyl Disposable Gloves (Box of 100 uni-handed vinyl)

£18.38 per litre, supplied in 2 x 500cc pots, plus VAT

1 litre Putty - Pallet knife -

Box of 100 gloves -

Complete Putty Kit - 1 x 1 litre of putty, box of gloves, putty knife -

Hand pump up sprayers for water based products, including our Boron Ultra 12 and Boracol 10RH insecticides and fungicides. Knapsack Sprayer - has a side lever arm action, for pumping whilst carrying the sprayer on one's back.

Frequently purchased with this product - Mask, Boron Ultra Gel, Box of Vinyl Gloves (100, uni-handed).

£26.70 for 5 litre Sprayer, £42.86 for a 12 - 20 litre Knapsack Sprayer, all plus VAT.

5 litre Sprayer 12 - 20 litre Knapsack Sprayer

Always kill the Mold and Algae first before painting, otherwise the mold spores and algae roots can grow through even the best paints.

Mix the Mold Cleaner Concentrate with water to make 5 litres of solution and wash down all affected surfaces with a sponge. Allow to dry.

Apply one or two coats of Stain Seal Primer over any stained areas. Allow to dry between coats.

Add one paint treatment concentrate to each 2.5 litres of masonry paint (any paint type) and mix thoroughly. Usage rate - mold & algae cleaner concentrate makes 5 litres, treats 40 square metres, Stain Seal primer paint covers up to 8 square metres per coat, Masonry Paint additives each treat 2.5 litres of your chosen paint.

Frequently purchased with this product - Instant Stain and Damp Seal spray.

Mold & Algae Cleaner Cleaner - concentrate

Paint Additive 50cc

1. Wash down the walls with Mold and Algae Cleaner. Allow to dry without rinsing.

2. Apply Stain Sealer or Instant Stain and Damp spray to stained areas.

3. Mix apply the Masonry Paint - use 1 x 50cc Paint Additive per 2.5 litres

Stain and Damp Primer 1 litre

Buy Instant Damp Stop Spray, 380cc, - seals damp and 'salty' patches, then Prime over.

A clear impervious coating that prevents mould and stains. Can be applied to paviers, slabs, tiles, concrete and masonry. Seals joints and resists traffic wear. Usage rate - Covers approximately 6 square metres per litre = 30 square metres per 5 litre.

Frequently purchased with this product - UltraProof Water Repellent (for walls).